SLV40 with vertical twistlocks

 

The industry must innovate to address container handling demand and this is just what Bromma did with the SLV40 - it is set to revolutionize the way drivers operate with the spreader increasing efficiency and productivity for a minimized total cost of ownership. The visual contact with the stack, container corners and twistlocks has been optimized.

The spreader can adjust its length to lift empty containers from 20’ to 40’ with a height from 8’ to 9’6” and a width from 8’ to 2500mm (Binnen containers) using ISO twistlocks. Mechanical Pile Slope (MPS) and side shift features enable easy location onto containers.

The telescopic spreader is of a low height monobeam frame construction which is shorter than the containers. Its specific design offers better visibility to position easily and rapidly the twistlocks heads onto the containers, which will remain accessible even when they are fully block-stacked. Both the spreader and the side shift carriage are designed to be optimally integrated into the lifting mast with high strength roller bearings (optional) and to minimize the Loss of Load Centre (LLC). Two ISO twistlocks engage the containers top apertures and lock into the top corner castings. A mechanical and electrical safety system prevents the locking and release of the twistlocks if the spreader is not correctly positioned against the container.

The SLV40 is controlled with 24 V DC solenoid operated valves and inductive proximity sensors. The electrical system is designed to ensure maximum safety during operation. All motions of the spreader are controlled from the driver’s cab over serial communication (CANopen) or parallel wiring (optional) and all commands are processed safely by the spreader Electronic Control Unit (ECU). Lifting allowance is monitored by the ECU and implemented on the lift truck to ensure safe container handling. In addition, the onboard ECU offers self-diagnostic technology, derived from Bromma’s innovative SCS³ crane spreader control system.

Made of high quality steel and components, the SLV40 spreader achieves greater performances with low tare weight, extended service intervals and longer likely replacement cycles. Available with several options, the Bromma SLV40 will enhance driver’s experience for a maximum productivity.

 

LIFTING CAPACITY (SWL)	9 t
TARE WEIGHT (TW)	3’100 kg (spreader only) approximately, without extra equipment ~1’500 kg for the sideshift carriage depending on mast interface
ISO TWISTLOCKS	90° in less than 1,5 sec mechanical & electrical safety interlock system
TELESCOPING	20’ to 40’ in less than 15 sec analogue sensing of telescoping positions and dampening with maximum speed
SIDESHIFT	±600 mm with smooth control technology
MECHANICAL PILE SLOPE	up to ±3° self-levelling MPS in side shift carriage in combination with 200mm float & spring loaded vertical heads
ELECTRICS	24 V DC control voltage Electronic Control Unit with diagnostic technology Serial interface CANopen according to CiA DS 444 profile 2 working lights 70W each 3 indication lights unlocked (G) – landed (Y) – locked (R)
HYDRAULICS	70-90 l/mn at 160 bar ISO cleanliness rating 18/16/13 (ISO 4406)
SURFACE CONDITIONING	PUR RAL 7021 (black grey) 120/2 FeSA2,5 with gloss grade 30±5  for a corrosion protection classification C3L/C2M according to EN - ISO 12944

 

An extensive list of options enables you to adapt the spreader more precisely to your needs. Further information is available on request. This specification is subject to alterations without prior notice.